home *** CD-ROM | disk | FTP | other *** search
Norton Commander module message | 1995-02-07 | 6.6 KB | 299 lines |
- Abort
- Allow ~Hard Disk Formatting
- The command line options are
- invalid for drive %c1:
- Format diskette will use the default settings.
- MSDOS SYS
- C~ancel
- Cancel
- COMMAND.COM
- %a2%i1%a0%% Complete
- Compressed
- Configuration
- DBLSPACE.BIN
- Error on device %s1:
- x: xx"
- x: xx"
- Error on drive %c1
- DRVSPACE.BIN
- Auto Detect
- Drive %c1: can't be formatted.
- Attempt to write on write-protected disk.
- Printer out of paper.
- Write fault.
- Read fault.
- Sharing violation or disk not formatted.
- Network error.
- Sharing violation.
- Unknown disk drive.
- Drive or device not ready.
- Unknown command.
- Data error.
- Bad request.
- Seek error.
- Non-DOS disk.
- Sector not found.
- Error
- Error
- ~Floppy Drive
- %69gb
- %35u8
- %35u9
- %37gb
- Estimated Time:
- Elapsed Time:
- %30gb
- Total Space: K
- System Space: - K
- Bad Space: - K
-
- Drive: %a2%S1%a0
- Usable Space: K
- %a2Press Esc or click mouse%a0
- %a2to interrupt formatting.%a0
- Size: %a2%S2%a0
- Volume: %a2%S3%a0
- System Mode: %a2%s4%a0
- Format Mode: %a2%s5%a0
- Image Info: %a2%s6%a0
- %37gb
- %35u7
- Formatting %c1:
- Formatting Cylinder %a2%i1%a0, Head %a2%i2%a0
- Format diskette
- %a2Format Terminated%a0
- Hard Disk
- Fixed
- %a2Drive %c1: is a hard disk.%a0
- You cannot format drive %c1: until hard disk
- formating has been enabled from the Configure dialog.
- Previous
- Index
- is corrupted.
- NC 5.0 Help a
- nc.hlp
- The Norton Commander, Version 5.0
- Copyright (C) 1986-1995 by Symantec Corporation.
- February 95, Created by John Socha. V.5 by Derek White
- The help file
- has an invalid version number.
- Insufficient memory
- to load help.
- Sorry, help is not available.
- There was an error reading data
- from the help file.
- Help
- Not enough memory
- ~Format
- ~Configure
- E~xit
- %20gbDrive
- %C6
- %R1
- %33gbFormat Type
- %R2
- %20gbSize
- %R3
- %33gbOptions
- Volume Label [%11t4]
- %C5
- ~Make Disk Bootable
- ~Make System Disk
- %a2Format Terminated%a0
- Warning!
- The new size of the disk
- must be the same as the
- current size.
- A Quick Format can't
- be performed on bad
- or unformatted disk.
- Try Safe Mode Format or
- DOS Mode Format.
- The disk cannot be read or has not been formatted.
- You must use DOS Format to format this disk.
- MSDOS SYS
- Error
- %a2Unrecoverable Error!%a0
- The disk in drive %c1: has a
- physical unrecoverable error
- in the system area,
- or is an incompatible size.
- It can't be formatted.
- No system files
- System files
- Leave room
- IBMBIO COM
- Saved
- Not Saved
- Quick
- Formatting Cylinder %a2%d1%a0, Head %a2%d2%a0
- %a2%d%a0%% Complete
- IBMDOS COM
- IO SYS
- Formatting %c1:
- ~Stop
- %a2WARNING%a0
- TBIOS SYS
- Drive %c1: contains one or more
- compressed drives. Formatting this
- drive will destroy those compressed
- drives and all the files they contain.
- Drive %c1: has the following
- files and subdirectories on it:
- %L2
- Are you sure you want to format it?
- DBLSPACE.BIN
- STACKER.BIN
- TDOS SYS
- DRVSPACE.BIN
- COMMAND.COM
- Use ~New Path
- ~Cancel
- A command interpreter could not be found.
- To continue with this operation you need
- to specify the location of a command
- interpreter such as COMMAND.COM or NDOS.COM
- on your hard disk.
- %T1
- MIO SYS
- The system file cannot be found.
- Do you wish to %a2STOP%a0 trying to locate
- the system file?
- %a2Norton Backup diskette using
- proprietary format found.%a0
- These types of diskettes cannot
- be reformatted using the %a2Quick%a0
- or %a2Safe%a0 format modes.
- %a2This diskette was formatted with a
- proprietary formatting technique.%a0
- IO BIN
- It cannot be reformatted using the
- %a2Quick%a0 or %a2Safe%a0 format modes.
- Drive %c1: is a compressed drive that cannot be formatted.
- Either use the OEM utility to reformat the compressed
- drive or unmount the volume and try again.
- Drive %c1: is a compressed drive that cannot be formatted.
- Either use the OEM utility to reformat the compressed
- drive or select the host drive %c2: from the main screen.
- ORIG_COM
- DRBIOS SYS
- Address mark not found
- Write-protected disk
- Sector not found
- Media has been changed
- DMA failure
- Bad DMA address
- Bad sector flag detected
- Bad cylinder detected
- Invalid media type
- ECC/CRC error
- SF.INI
- DRBDOS SYS
- Controller failure
- Seek failure
- Drive is not ready
- %20gb
- x:yIBMBIO.COM
- x:yIBMDOS.COM
- x:yIO.SYS
- x:yTBIOS.SYS
- x:yTDOS.SYS
- ~Format It
- x:yMIO.SYS
- x:yIO.BIN
- x:yDRBIOS.SYS
- x:yDRBDOS.SYS
- x:yCOMMAND.COM
- Unable to find valid system files.
- Insufficient memory for system transfer.
- System File location not supplied.
- Error writing the new system area
- Updating the system area...
- ~Cancel
- Saving Image info...
- Analyzing disk information...
- Drive %c1: has been
- successfully formatted.
- Setting the volume label...
- Error setting the volume label
- Transferring the system files...
- Leaving space for the system files...
- Error transferring the system files
- Error leaving space for the system files
- %a2Drive %c1: is a hard disk.%a0
- System files not transferred.
- The disk is unsuitable
- to be a system disk.
- Room cannot be left for the System files.
- The disk is unsuitable
- to be a system disk.
- Correct the problem and try again.
- Unknown disk error - %xh
- 00:00:00
- No volume label
- You can cancel the format at
- anytime by pressing %a2ESC%a0.
- This hard disk can't be formatted.
- The system area is defective.
- %a2This hard disk can't be formatted.%a0
- The disk type can't be determined.
- Format diskette will only format hard
- disks with 512-byte sectors.
- Unable to reset the drive
- The disk is missing from the drive.
- Please insert a disk.
- Please insert a disk.
- Are you absolutely sure you
- An error occurred while saving Image info.
- %a2Image info not saved.%a0
- Do you want to continue with the format?
- The DOS Format mode DESTROYS all
- information on the diskette. The
- diskette cannot be unformatted.
- Are you sure you want to format this
- diskette using the DOS Format mode?
- Unable to read the root directory
- Unable to write the root directory
- want to format drive %c1:?
- Please insert a DOS diskette
- into drive A:
- Remove the system disk from drive A:
- and re-insert the disk to format.
- The disk is either a different size,
- has bad system values, or is damaged.
- Image info cannot be saved on this disk.
- Do you wish to continue with the format?
- A Quick Format can't be
- performed on this disk.
- x:yMSDOS.SYS
- ncff.exe
- Not enough memory to continue.
- Format diskette will not run in OS/2's compatibility mode
- No volume label
- Not Saved
- Saved
- ~Prompt for Missing Diskettes
- Retry
- Save ~Image Info
- S~ave Settings on Exit
- SF.INI
- Hard Disk
- 18~0K
- 3~60K
- 1.~2M
- 1.~4M
- 2.~8M
- STACKER.BIN
- Put on disk
- Leave space
- Unknown disk error - %ih
- x:yDBLSPACE.BIN
- x:yDRVSPACE.BIN
- x:ySTACKER.BIN
- %22gType for Drive A:
- Quick
- Warning!
- The size specified is not
- valid for this drive.
- The default size will be used.
-